Thank you for choosing the IQ VIVA!
We hope you enjoy your new device.
HOW TO USE
1. Adjust airflow
Screw airflow ring to adjust airflow to custom your own flaovr.
2. E-Liquid filling
Press and screw counter clockwise direction to remove top cap.
Fill e-liquid through filling hole on the both sides of top lid. Please do not fill e-liquid into the air hole in the middle.
Press and screw clockwise direction to replace top cap to vape.
CAUTION
1.When refilling with a new coil for the first time, please wait for a few minutes after refilling so that the new coil can be completely soaked; this prevents experiencing a dry hit
HOW TO CHANGE COIL
1.First empty the tank of all e-liquid, the unscrew the base to gain access to the coil
2.Make sure to clean any residual e-liquid from the coil before removing it from the base
3.Screw the new coil back onto the base, then properly wick the cotton inside of the coil before reinstalling the glass and top cap.
HOW TO USE
1. Switch ON/OFF
Press fire key 5 times consecutively to switch ON/OFF your device.
2. Adjust voltage level
Press fire key 3 times in 1.5 seconds to adjust voltage level.
Voltage LED flashes 3 times and battery LED will turn off in 2 seconds.
3. Vaping
The battery and voltage LED both turn on, then the voltage LED turns off immediately. The battery LED will turn off in 2 seconds later while stop vaping.
4. Lock/Unlock
Press fire key 5 times in 2 seconds to ock/unlock your device, battery and voltage LED both flash 3 times while locking/unlocking, and the battery LED turns off in 2 seconds later while unlocking.
HOW TO CHARGE
1. Device Charging
Connects USB cable to charge, battery LED flashing while Charging, and keep lighting while fully charged.
2. Battery LED in Red: Power < 30%
3. Battery LED in Blue: 30% < Power < 70%
4. Battery LED in Purple: Power > 70%
Multiple Protections
1. Short circuit protection
Battery LED turn off, voltage LED flash 10 times quickly, atomizer stop working.
2. Overtime protection
Atomizer will stop working if you inhale/puff for longer than 10 seconds, voltage LED will flash 10 times.
3. Over-charge protection
Device stop charging while detects battery Fully charged.
4. Low voltage protection
Device stop working when battery voltage low, battery LED flash 5 times quickly and voltage LED turn off.